If the faucet is not properly maintained after selection, its service life will be affected, which is a headache for many people. Faucets are used frequently. They are used every day. Under such a high frequency of use, how can we maintain the faucet and increase its service life? In fact, this is not a difficult thing. Now, as long as the installation, operation and maintenance are correct and correct, the actual service life of the faucet can not only be extended, but also can always be bright as new.
1. When the air temperature is lower than 0 ℃, if the handle of the faucet feels abnormal, it can be used only when the handle feels normal with hot water. Otherwise, the service life of the faucet valve element will be affected.
2. The phenomenon of water dripping will appear after the faucet is closed, because the opening of the faucet is caused by the residual water in the inner cavity of the faucet, which is a normal phenomenon. If water drips for more than ten minutes for a long time, it is a water leak, indicating that the product has a quality problem.
3. Because the water contains a small amount of carbonic acid, the scale formed simply after the metal surface transpiration will corrode the faucet surface, affecting the cleaning and service life of the faucet. Therefore, after using the faucet, always use soft cotton cloth or sponge and neutral soap water to scrub the faucet surface (note: do not scrub with corrosive or acidic articles), and then use soft cloth to dry the surface. Do not use metal wire or cleaning cloth with hard particles.
4. Don't use too much force to open and close the faucet, just roll it gently. Even traditional faucets do not need to be screwed to death. In particular, do not support or use the handle as a handrail. Many people are used to turning off the tap after using it, which is very undesirable. Not only will it not prevent water leakage, but it will damage the sealing valve and cause the faucet to not be closed tightly.
5. When the water flow decreases, impurities shall be removed. If the water pressure is not less than 0.02 mpa, if the water output is reduced, it may be that the tap is blocked. The solution is to use a wrench to gently screw the water nozzle screen cover at the water outlet of the faucet, clean the impurities, and then carefully install them. Generally, they can recover as before.